Ferritic-martensitic stainless steel: This type of stainless steel is in a γ+α (or δ) two-phase state at high temperature, and γ-M transformation occurs when rapidly cooling, ferrite is still retained, and the normal temperature structure is martensite and Ferrite, due to the difference in composition and heating temperature, the ferrite content in the structure can vary from a few percent to several tens of percent.
0Cr13 steel, 1Cr13 steel, 2Cr13 steel with the upper limit of chromium and the lower limit of carbon, Cr17Ni2 steel, Cr17wn4 steel, and many modified 12% chromium heat-strength steels developed on the basis of ICr13 steel (this type of steel is also called heat-resistant stainless steel. ) in many steel grades, such as Cr11MoV, Cr12WMoV, Cr12W4MoV, 18Cr12WMoVNb, etc. belong to this category.
Ferritic-martensitic stainless steels can be partially quenched and strengthened, so higher mechanical properties can be obtained. However, their mechanical properties and process properties are largely affected by the content and distribution of ferrite in the microstructure. This type of stainless steel is divided into two series according to the chromium content in the composition, 12~14% and 15~18%.
The former has the ability to resist the atmosphere and weak corrosive medium, and has good shock absorption and small linear expansion coefficient; the latter has the same corrosion resistance as the ferritic acid-resistant stainless steel with the same chromium content, but to a certain extent It also retains some of the shortcomings of high-chromium ferritic stainless steel.

