1. In order to ensure the service life of the pipe cutting machine, it is necessary to inject the oil or equipment-specific oil into the oil hole marked with red dot in each part of the machine and the rotating parts of the chain and gear before starting the machine. The machine must rotate in a clockwise direction. Do not reverse, so as not to cause problems such as rolling and damage to the machine.
2. Please use the correct voltage. The input voltage error range should be within ±10V and ensure that the machine should be properly grounded to prevent damage caused by machine leakage.
3. Before making any adjustments to the pipe cutting machine, be sure to turn off the power first, and unplug the plug to ensure safety. Do not let children and non-operators come close to avoid danger.
4. When the dust is cleaned by blowing air in the computer box, no water vapor should be sprayed out. If any, please let the air compressor be drained.
5. In the place where the gas is smashed, the butter in the machine may freeze in the case. Please use the manual adjustment hole to insert the L8 wrench, circumvent the direction indicated on the cover, and add the normal temperature oil to the lubrication position. Slowly bypass the knife edge and you can use it.
6. The rear of the machine is about 40mm away from the rear of the machine. The left and right sides must be reserved for maintenance.
7. Please take extra care when changing the tool to avoid cuts. Please also be sure to unplug the power plu