Stainless Steel Tempering Effect On Properties

Sep 07, 2022

Leave a message

A heat treatment process in which the quenched martensite steel is heated to a temperature below the critical point A1, kept for an appropriate time, and then cooled to room temperature. The purpose of tempering is to eliminate the quenching stress and transform the structure of the steel into a relatively stable state. Improve the ductility and toughness of the steel without reducing or appropriately reducing the hardness and strength of the steel to obtain the desired properties. Medium carbon and high carbon steels are usually very hard after quenching, but very brittle and generally require tempering before they can be used.

The quenched martensite in steel is a supersaturated solid solution of carbon in α-Fe, with a body-centered square structure, and its squareness c/a increases with the increase of carbon content (c/a=1+0.045wt %C). The martensite structure is thermodynamically unstable and tends to transition to a stable structure. Many steels still have a certain amount of retained austenite after quenching, which is also unstable and will transform during tempering. Therefore, the tempering process is essentially a complex transformation process that heats pure fire steel within a certain temperature range to make the thermodynamically unstable microstructure in the steel transition to a stable state. The content and form of transformation vary depending on the chemical composition and structure of the quenched steel, as well as the heating temperature (see martensitic transformation).

The third step in conditioning hardened steel for use is usually tempering. Most steels cannot be used in the quenched condition, except for austempered steels, which are usually used in the quenched condition. The chilling used to generate martensite makes the steel very hard, resulting in macroscopic internal stress and microscopic internal stress, making the material very low in plasticity and extremely brittle. To reduce this hazard, the steel can be reheated to a temperature below the low temperature transition of the A1 line. The structural changes that occur when quenched steel is tempered are a function of time and temperature, with temperature being the most important. It must be emphasized that tempering is not a hardening method, but the exact opposite.

Tempered steel is a steel that has been hardened by heat treatment to release stress, soften and increase plasticity by reheating during tempering. Structural changes and changes in properties caused by tempering depend on the temperature at which the steel is reheated. The higher the temperature, the greater the effect, so the choice of temperature often depends on the degree to which hardness and strength are sacrificed for plasticity and toughness. Reheating below 100°C has little effect on quenched plain carbon steel. Some changes will occur in the structure between 100°C and 200°C, and the structure and properties will change significantly above 200°C.

Prolonged heating just below the A1 temperature produces a spheroidized structure similar to the spheroidizing annealing process. In industry, tempering in the range of 250°C to 425°C is generally avoided because steel tempered in this range often exhibits unexplained brittleness or loss of plasticity. Some alloy steels in the 425°C to 600°C range also develop "temper brittleness", especially when cooled slowly from (or through) this temperature range. When these steels must be tempered at high temperatures, they are usually heated to above 600°C and cooled rapidly. Of course, rapid cooling from this temperature will not produce hardening, since no austenitization has taken place.

format,f_auto.webp