1. The hardware sheet stamping equipment should have nameplates, various operating instructions, safety and warning instructions.
2. The power supply wiring should be standardized. The cables of the equipment should not be damaged to prevent aging.
3. The key of the distribution box door on the stamping equipment shall be provided with a key, and the door will be automatically cut off.
4. The conversion of single, continuous, foot press and other operations should adopt the switch with key lock.
5. In the single stroke operation of the hardware iron punching equipment, continuous stamping stroke shall not occur.
6. When selecting a continuous stroke operation, a pre-control action link should be provided during the operation.
7. There must be an emergency stop button on the stamping device and it should be self-locking.
8. There should be chain control between pedal operation and hand operation.
9. Protective covers shall be installed on transmission gears, belt pulleys, flywheels, and levers that are exposed outside the fuselage and at the top of the fuselage.
10. Pedal Hardware The iron sheet stamping operation device adopts a foot pedal type to control the electric switch by pedals and reset automatically.