1. The safety procedures of the machining center must be observed.
2. Before work, wear protective equipment and tie the cuffs. Do not wear scarves, gloves, ties, and aprons. Women's hair should be worn inside the hat.
3. Check whether the tool compensation, machine zero, and workpiece zero are correct before turning on the machine.
4. The relative position of each button should meet the operating requirements. Carefully prepare and input numerical control programs.
5. To check the operation status of the equipment on the protection, insurance, signal, location, mechanical transmission part, electrical, hydraulic, digital display, etc., under all normal conditions can be cut.
6. Before the machine tool is commissioned before machining, the operating conditions of the lubrication, mechanical, electrical, hydraulic, and digital display systems shall be checked. Cutting operations may be performed under all normal conditions.
7. After the machine tool enters the machining operation according to the program, the operator is not allowed to touch the moving workpiece, the tool and the transmission part, and it is forbidden to transfer or retrieve the tool and other items across the rotating part of the machine tool.
8. When you adjust the machine, set up the workpiece and tool, and wipe the machine, you must stop.
9. Tools or other items must not be placed on electrical appliances, control cabinets, and protective covers.
10. Do not remove iron directly by hand. Use special tools for cleaning.
11. When abnormal conditions and alarm signals are found, they should stop immediately and ask relevant personnel to check.
12. It is forbidden to leave the work station when the machine tool is running. For reasons of leaving, the work bench is placed in the middle position, the tool bar is returned, the parking must be stopped, and the power supply of the host computer is cut off.