Many steps in the CNC machining process are likely to cause potential safety hazards if they do not pay attention to the standard operation. In order to improve the processing efficiency and reduce the losses caused by the operation errors, CNC machining must always pay attention to the standard operation, the following is the development of CNC machining operation specification
1. Assemble the material as far as possible and then install the tool, this can prevent the material being hand cut by the tool, but if the tool is already installed, you should first remove the table, so as to ensure not with the tool Generate interference
2. Be sure to remove the tool after the spindle stops completely.
3. When removing the tool, do not directly hold the blade of the tool by hand to avoid being cut.
4. During the machining of precision parts, the operator must not observe the cutting state too closely to prevent the chips from entering the eyes.
5. The tools to be used should be placed in the designated tool storage area after use.
6. Precise machining of parts Before the machine starts, it is necessary to check the position of the oil nozzle of the oil pump to prevent the oil from spraying to other locations.
7. Machining clearance If you want to pause the observation, it is necessary to first move the table out of the cutting position