1, try to install the card material and then install the card tool to prevent the hand touch the tool when installing the card material. If the tool is already installed, when the material is loaded, the workbench should first be moved to the outside to ensure that when the material is installed, it will not interfere with the tool to prevent injury or breakage of the tool.
2. When disassembling the tool, be sure to first observe whether the spindle stops rotating.
3. Do not forcefully hold or knives the edge of the cutter when unloading the knife to avoid scratching the blade.
4, the use of the wrench should be placed in the tool storage area, not allowed on the Y-axis shield or beam.
5. During the processing, the operator is not allowed to observe the cutting position at close range to prevent the chip from falling into the eyes.
6. Check the position of the nozzle before turning on the switch of the oil pump before the start of processing to avoid spraying to other positions when the oil is pumped.
7. When suspending observation during the processing gap, be sure to move the table away from the cutting position.
8, inspection After we finish the processing, before disassembling the workpiece, we must first carry out the preliminary inspection of the necessary size or appearance. After inspection, we can disassemble the workpiece to avoid positioning problem of the secondary processing and causing the workpiece to be scrapped. The disassembled workpieces are further tested for some key dimensional data to finally meet the processing requirements.